Hot schedules price8/5/2023 ![]() This week, they purchased 10lb of cucumbers at $2.00 per pound.A store purchased 10lb of cucumbers at $1.00 per pound last week.As prices fluctuate, the unit price will display the weighted average price. Select the (i) under the 'Band' headingĪll available price band pricing will be displayed (see Fig.3).įig.Unit cost price is derived from the original unit price inserted into the system via the order guides.It is possible to see all price band pricing held against an Ingredient from Master Data Receiving and Invoice reconciliation will happen as normal. Orders will be placed, and expected Goods Received Notes will be created, with this value. Placing Orders and Reviewing Price Band Prices Placing OrdersĪt the point ingredient lists are loaded for ordering in either the mobile app or Inventory, the above linking will be checked to determine the required pricing that is displayed. This should be completed for all existing Supplier/Site combinations.įig.1 - Supplier / Site / Price Band linking Select the required price band from the drop-down for each site and then Save.Select all required locations and then NextĪ screen will then display where a price band can be assigned to each site.Alternatively, to assign a supplier to a site for the first time, select Add Supplier/Price Band to Site/Change Depot.For existing Site/Supplier combinations select Update Nominal Code/Price Band to Site.Navigate to Setup > All Options > Browser Suppliers.This linking controls the price that a site will see when creating an order for a supplier.Īll stock-related pricing will be based on the Average Weighted Cost as usual Once the global setting is enabled, and ingredient price band data synced, links must be created between: Price band data will only be synced for price bands with pricing held against ingredients exported to Inventory. Orders cannot be placed until all configuration is in place, so the timing of configuration on a live organisation must be carefully considered and planned with a Fourth representative. Once enabled, a full sync of ingredient data to Inventory is required before the following configuration can be completed. The above global setting should not be enabled until all price band data is ready in RME. Global Settings > Products > Organisation Settings > Default > Apply Product Banding to Organisation. ![]() ![]() Configuration Global SettingĪ Fourth representative must enable the following global setting once all data is configured in RME: Therefore in Inventory it is configuration, review, and use only - no management. These price bands are then applied to specific site and supplier combinations to control the prices for ordering and stock purposes.Īll price band data in Inventory is managed in RME. ![]() ![]() If price bands are configured in RME, they must also be configured in Inventory. However, additional price bands can be configured where required. In Recipe & Menu Engineering (RME), by default, a single price band exists. This could be for regional pricing differences or contractual reasons, for example. Price band functionality allows the maintaining of a single product with a single product code from a single supplier, but with varying prices applied. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |